Delaware Professional Engineer Seals

Delaware Engineer Seal Requirements

Each licensee shall obtain an embossing seal of the design authorized by the Council, bearing the licensee's name, license number, and the legend "professional engineer." In addition to the embossing seal required by the foregoing provisions of this section licensees may procure and use a stamp containing the same data as the embossing seal.

Delaware Land Surveyor Seal Requirements

A raised seal shall be used wherever possible. When a raised seal cannot be used, a rubber seal may be used, but only with red ink so that the lettering will stand out. The seal to be used by a Delaware licensee shall conform to the above regulation and have two concentric circles. The inner circle shall contain only the words "REGISTERED," "NO.," and "DELAWARE." The area between the circles shall contain, at the bottom, the words "PROFESSIONAL LAND SURVEYOR" reading counterclockwise and at the top, the name of the licensee as written below, reading clockwise. The seal acceptable to the board has an inner circle 1" in diameter and an outer circle 1 1/2" in diameter.

Delaware Architect Seal Requirements

Pursuant to 24 Del.C. §313 and subject to 6.7 and 7.5, each architect shall procure a seal, which shall contain the name of the architect, his/her registration number and the phrase REGISTERED ARCHITECT - STATE OF DELAWARE. The architect shall use his/her legal name on the Certificate of Registration, the seal and the license.

Order Your Engineer Seal or Land Surveyor

3 Easy Steps

First, Choose your Professional Seal from the selection below